5" cross slide travel for 7x12s
#1
Having trouble getting around big diameter's on your 7x-- try this.

.pdf   New 7x12 cross slide feed screw 5.pdf (Size: 1.48 MB / Downloads: 65)

Problem solved. Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#2
Brian, Thanks for the write up.

Did you relocate the cross slide nut to allow increased travel toward the operator? I think what most mini lathe owners have done is to mill out material in the cross slide base. Here are two examples:
http://gadgetbuilder.com/CrossSlide.html
http://mikesworkshop.weebly.com/cross-sl...ravel.html

Can you show us about your half nuts and the new location?

Regards,
Mike
MikeK, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
#3
Hi Mike
One of rhe early jobs I did on the lathe years ago was to mill out the slot in the saddle and add a spacer to get more travel
but you loose an equal amount at the opposite end of the travel, the new feed screw cures this.its a old mod as is
spliting the nut into two, is a very old 7x10 mod I dont know who did it first, but I have added a couple of refinements to make it Even better the location remains the same.
I will do another post later covering this and other work.

Brian
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#4
(11-13-2013, 03:45 PM)Brian Wrote: ...
I will do another post later covering this and other work.

Brian

Please do. Drool

Ed
Reply
Thanks given by:
#5
Hi Mike.
I found a photo of the mod to the saddle slot showing the extra area milled out and the spacer to push the lead screw out to get more room towards the front of the lathe.
   

HQ is calling dinner more later.
Brian
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)