hi all i got this today it just needed my loving touch in all it is OK a part from the mane shaft so it got striped dawn in pic 3 you will see the notch cut out in the bezel to remove the retaining ring once this was out it all came a part with ease and all was given a good scrub up
once a part their was two things that needed downing one repairing the plunger rod two reaper the base cover i reaped the plunger rob by cutting the end off and drilling 1.6mm by 6 deep then taping with a m2 tap i then made a new bottom length of rod and drilled both ends 1.6mm by 6 deep then taped them m2 then with sum Bering fit and a length of m2 studding i jond the two together as for the back i just cleaned up the part that sum one had made before and silver soldered it to the back right pics
(04-07-2013, 05:40 PM)krv3000 Wrote: [ -> ]in pic 3 you will see the notch cut out in the bezel to remove the retaining ring once this was out it all came a part with ease and all was given a good scrub up
( Yawn, Ho Hum)
I still haven't found the "notch".
The bezel is the "glass" right?
Darren, is it easier to see things "down under"?
Thanx man!