MetalworkingFun Forum

[attachment=5466]

Here is a better view of the wire wheel set-up:

[attachment=5467]

Here you go Darren.

The article: http://www.machinistblog.com/a-chip-brus...6-bandsaw/

The plans: http://www.machinistblog.com/downloads/A...andsaw.pdf

That project has been on my list for quite awhile now. I even bought the brushes for it but have just not gotten around to making the modification.

Ed

This is how I did it.



DaveH

Dave, did you make that bracket? It looks like a factory made part.

Willie & DaveH, thanks for the circular brush idea. It's now on my list (my long, long list, sigh).

(06-10-2013, 04:48 PM)Highpower Wrote: [ -> ]Dave, did you make that bracket? It looks like a factory made part.

Sure did, I assume you meant it as a compliment

DaveH

DaveH, I'm sure he meant "non Asian factory made".

(06-10-2013, 07:28 PM)stevec Wrote: [ -> ]DaveH, I'm sure he meant "non Asian factory made".

Good point Steve! I guess I should have said it looks TOO good to be a factory part in that case.

It's obviously a heavier bracket than what is on my saw.