07-02-2013, 07:12 AM
I have been busy making aluminum QCTP tool holders for those once in a while tools that we hate to take another tool out of its holder to use.
Last night I was making the knurled wheels (matl aluminum) for setting tool height. I drilled a piece of al bar and tapped for the height screw, sectioned off 4 wheels, and chamfered the edges. My question is, can I grind a parting blade with a slight angle on the tip to cut the parted piece clean? How much angle?
[attachment=5580]
Chuck
Last night I was making the knurled wheels (matl aluminum) for setting tool height. I drilled a piece of al bar and tapped for the height screw, sectioned off 4 wheels, and chamfered the edges. My question is, can I grind a parting blade with a slight angle on the tip to cut the parted piece clean? How much angle?
[attachment=5580]
Chuck