03-15-2014, 03:36 PM
04-10-2014, 08:07 AM
finally got the part shown in the last video on the shaper it still needs a couple finishing touches.
[attachment=8098]
and the handle that a friend in Tulsa cut the pattern for with his CNC Router
[attachment=8099]
I've made and adjustment to the pattern by removing the rounded part because of the length of the stud that is in the shaper (original part), I plan on scaling the pattern up a little its on the small side for getting a good grip on. But it looks a heck of a lot better then the other one that I cut the pattern for with a pocket knife.
DA
[attachment=8098]
and the handle that a friend in Tulsa cut the pattern for with his CNC Router
[attachment=8099]
I've made and adjustment to the pattern by removing the rounded part because of the length of the stud that is in the shaper (original part), I plan on scaling the pattern up a little its on the small side for getting a good grip on. But it looks a heck of a lot better then the other one that I cut the pattern for with a pocket knife.
DA
04-13-2014, 04:42 PM
made the thumb screw that I need for the leadscrew support shown in the above photo
small part with a big pucker factor, the gods smiled and I only had to make the one.
[attachment=8116]
small part with a big pucker factor, the gods smiled and I only had to make the one.
[attachment=8116]