hi all well i have a set of cobalt drills that go up in .5mm steps to 11.5 so rather than them laying in a tub i made this up today i have gone all the way up to 13mm don.t no where i got the aluminum angel from i cut 3 lengths of it 200mm long i then made two side panels divided the lengths up for the center of etch drill stuck it all together then started to No the drills IE 1 then 1.5 and so on but i run out of No 5s so i just cared on will go to wh smiths in the morning to get sum more right pics
Nice work Bob, always liked drill stands.
Seconded Bob, nice job !
Mike
Nice to see a drill stand that isn't so tightly packed that you cannot see the drill sizes. I have one where I have to count them to get the correct size. I have a letter size one that you can only see the letters on the first leaf
DaveH
Looking good Bob , nice to have the sizes big and be able to pick out one drill without removing a few just to be able to get hold of the one you need too , Well done.
Cheers Mick
Very nice, and plenty of room there to add the 3.15, 2.45, 5.5, and all the other in-between sizes you'll need....sooner or later.
