OK, here's the Rockwell.
I've added the VFD (Hitachi - thanks, Ed!)and the DRO (Shooting Star.) I went back and forth about mounting the X DRO rail on the front or the back. I preferred the back, but I would lose some travel. And the front would have been a lot more difficult, and made it less convenient to get to the table stops, and the lock handle.
When I mounted the 5" Kurt vise, though, it hung over enough on the back that I lost that travel, anyway. Problem solved.
Also, I replaced the stock handwheel handles (pressed in, with knurls, and they kept falling out) with larger, spinning handles. I had to drill out the holes, and use helicoils to fit the 8mm handle thread.
I agree. Nice machine and you did a great job setting it up.
Ditto. Now lets see some chips?
My Warco VMC. Only a few minor mods made to it!
Are you allowed back in the pool room where you got the balls for the quill handle.
Luckily nobody saw me ...
I found individual pool balls on eBay so it was just a matter of spots or stripes and what colour!
I do like these little knee mills, much more usable than a mill drill but smaller than a turret if only there was dual spindle, horizontal/vertical model. Hmmm, I can feel a project coming on.
Rick