MetalworkingFun Forum

MetalworkingFun Forum > Machining > Welding & Casting > Antique cast iron clamp part fixed
Full Version: Antique cast iron clamp part fixed
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

aametalmaster

09-08-2013, 05:52 PM
A guy at work dropped this part off and asked if i could weld it. Yup no problem i said. Fired up the MM185 with crown alloys .035 cast wire and 75/25 gas and tacked it together. Ran some beads and cleaned it up...Bob

EdK

09-08-2013, 06:05 PM
That must have made your customer happy. Nice job. Thumbsup

Ed

f350ca

09-08-2013, 07:54 PM
Nice repair Bo. Didn't know there was wire available for repairing cast, I've only ever used stick.

krv3000

09-09-2013, 03:00 PM
a job well dun

aametalmaster

09-09-2013, 07:33 PM
(09-08-2013, 07:54 PM)f350ca Wrote: [ -> ]Nice repair Bo. Didn't know there was wire available for repairing cast, I've only ever used stick.

And i have been waiting 30 years for it...Bob
MetalworkingFun Forum > Machining > Welding & Casting > Antique cast iron clamp part fixed