12-24-2013, 07:02 PM
Later on you might want to find one of those rotating battery-operated disks. I think that would add so much beauty if it were slowly spinning so the viewer could see both the cross shape and the fish shape as it spins.
12-24-2013, 07:02 PM
12-24-2013, 07:33 PM
12-26-2013, 09:08 PM
The wife seems to be happy with her gift.
![[Image: crossfish12.JPG]](http://www.arcaneiron.com/machines/crossfish12.JPG)
I ended up polishing it using an old 14" workbench Craftsman drill press I have in the basement. I used the Scotchbrite pad with an arbor on it and just chucked it up in the drill press. The polishing really causes all the machining marks, flaws, file marks, etc. to stand out (in my opinion) but it did give it a warmer more "antique" kind of feel to it.
The "proof in the pudding" as to how much my wife likes it will been her reaction when I tell her I'm buying more machining supplies/equipment. If I don't get the "eye roll" or the "look" I'll know that it was a "score!".
Thanks guys,
-Ron
I ended up polishing it using an old 14" workbench Craftsman drill press I have in the basement. I used the Scotchbrite pad with an arbor on it and just chucked it up in the drill press. The polishing really causes all the machining marks, flaws, file marks, etc. to stand out (in my opinion) but it did give it a warmer more "antique" kind of feel to it.
The "proof in the pudding" as to how much my wife likes it will been her reaction when I tell her I'm buying more machining supplies/equipment. If I don't get the "eye roll" or the "look" I'll know that it was a "score!".
Thanks guys,
-Ron
12-26-2013, 11:57 PM
12-27-2013, 12:12 AM
Looks like a success story to me Ron. 
Tom
Tom
12-27-2013, 02:51 AM
Now here's the problem...
Hmmmm, I already have the "plan" worked out. I know a few tricks that would make it a bit easier if I were to do more of them. I like the idea of a little rotating stand and I wonder what it would look like if I drilled (there's that boring bar) a hole in the center of the base and place a counter-sunk LED in there....
NO! Must not think this way.
No way do I want to do another one. 
It's a sickness!
Thanks for all the good words guys,
-Ron
Hmmmm, I already have the "plan" worked out. I know a few tricks that would make it a bit easier if I were to do more of them. I like the idea of a little rotating stand and I wonder what it would look like if I drilled (there's that boring bar
) a hole in the center of the base and place a counter-sunk LED in there....NO! Must not think this way.
No way do I want to do another one. It's a sickness!Thanks for all the good words guys,
-Ron