MetalworkingFun Forum

Full Version: Dual flight controls for simulator
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2 3 4 5 6 7 8
Man. That's an inspiring thought.
Pretty happy with the press fit bearing holes I bored today. The axle is a tight sliding fit in both bearings, had to use sandpaper to hit the mark but at least I didn't go past.

[Image: image.jpg]
Nice work Shawn, very nice Smiley-signs107 
Smiley-eatdrink004 
DaveH
Pages: 1 2 3 4 5 6 7 8