Got another part almost done but I ran out of time. I'll finish it up tomorrow.
The surface finish sucks so no shiny metal camera shot this time. I haven't figured out how to get a decent finish on O-1 tool steel.
Ed
[
attachment=9203]
Ed
Every part made is a step closer to the finish line , nice bit of screw cutting
Rob
Is that the piece in the drawing in you preceding post Ed?
(08-30-2014, 08:04 PM)Mayhem Wrote: [ -> ]Is that the piece in the drawing in you preceding post Ed?
Yes, and I know what you're thinking. The drawing shows a step down dimension in the area where the hole is drilled. I copied the original drawing from the article but once I got to the point of cutting it I decided it wasn't necessary and is stronger without the step. A handle goes into that hole and is used for clamping the arbor.
Oh, and I did change the drawing to remove the step.
Ed
That's the way I do it Ed. I work to the drawing and then when I'm done I revise the drawing to resemble the part I've made .