MetalworkingFun Forum

I'm considering buying an extended point/CNC point live centre, as recently I've encountered some difficulties in getting the tool in where I need it.

This is one that Enco does and I'm glad my lathe only has a MT3 tailstock. There is no brand name, only that it is USA made and it's less than 1/2 the price of the Royal one ($194.72 versus $443.15). I'm putting together an order to send to Ken, as I'll be dropping in to visit him next month when I'm in the US on business. With the free shipping and 10% discount with the current September codes, it doesn't hurt as much as it could...

Any thoughts/comments?

Darren,

I have that one. It sure has gone up in price. I think I paid about $120 for it. I have no complaints at all with it and I got it for the same reasons you're looking at it. Not the bargain basement one and not the real expensive one I can't justify. I settled for a middle of the road tool instead.

Ed

(09-09-2014, 08:16 AM)Mayhem Wrote: [ -> ]I'm considering buying an extended point/CNC point live centre, as recently I've encountered some difficulties in getting the tool in where I need it.

I hate when that happens....

Mayhem Wrote:This is one that Enco does and I'm glad my lathe only has a MT3 tailstock. There is no brand name, only that it is USA made and it's less than 1/2 the price of the Royal one ($194.72 versus $443.15).

I think "Made in USA" is the brand name. I've never seen anything that says they actually are made here.
I have other tools made by them though and haven't had any issues with them.

I "bought" a carbide tip half-center on ebay a couple of days ago for $19.95 and the listing showed "10 available". Got an email from the seller yesterday saying they "made an error" with the count, and they didn't have any.

http://spares.xyzmachinetools.com/Interc...204/LCIP3/

Hi Darren , I use this type with interchangeable points , other company's do them cheaper , think I payed about 80 UK quids for mine


Just a thought Rob

(09-09-2014, 03:20 PM)RobWilson. Wrote: [ -> ]http://spares.xyzmachinetools.com/Interc...204/LCIP3/

Hi Darren , I use this type with interchangeable points , other company's do them cheaper , think I payed about 80 UK quids for mine


Rob

I bought the same set after looking at the one Rob uses
Real nice bit of kit
John

Bunch of wusses - supposed to be 'home machinist's' ...... Make one. It's all in the bearings

DaveH

I did think about that Dave but it is finding the time...

(09-09-2014, 06:43 PM)DaveH Wrote: [ -> ]Bunch of wusses - supposed to be 'home machinist's' ...... Make one. It's all in the bearings

DaveH

Go for it Dave,show us how it's done


Rob

I double dare you

Didn't you make a couple of pipe centres Rob?

I did Darren

Can't post photos at the moment .


Rob