Hi
Lads
Made this dummy lathe spindle nose
2 1/4 inch / 6 TPI Whitworth
Hardinium steel
High speed tool ground to 55 deg
Top slide set to 28 deg
Playing with the macro
There will be a bit video as well
John
Hi John , quality work there lad I am sure the customer will be very happy
A video too eh
Cheers Mick
Be happy until he gets the bill
John
Aye screw him John
, good job mate
,,,,,,,,,,,is that a bit of that bar I picked up on me travels
Rob
Hi
Rob
It is that bar you "picked up"
Good to machine
Shiney on the inside as well
That is the protractor I got from you as well
John
Arh so it is John
,good to see it still in use .
It is good to machine ,tough as old boots ,but you do get a good finish when machining it.I will grab a few more lengths
.
Rob