I was asked if I could "drill" this out
Snapped tap been well got at
Ground the top away
Nice clean metal
Welded ready for some file work & re tapping
John
Nice work John. That looked a decent size tap to have been snapped...
Good work John (as usual, ho-hum). Looks like the tap was pretty near bottomed when it broke. The casting is aluminum, right?
Did you give any thought to putting in a copper "bolt" once you pried the tap out and then welding over it and then onscrewing the bolt?
It helps to assure the alignment/position of the tapped hole is retained.
carnt even spell john right
Bob, I think jhone looks better than John anyway.
SteveC
Nice going mate , dam shame they never snapped one in the other hole too
Rob