Hi
Lads
I was given this boring head today
Any ideas on a R8 spindle / mandrel for it
I can always make one
The centre hole is 40 mill
Regards
John
like Awemawson said buy a threaded arbor and make a plate
I have a spare R8 to a Jacobs taper I will modify that
It is a nice looking boring head
John
I hope it's one of the beefier Jacobs tapers then - that looks to be quite a chunky head !
I will turn off the taper then ether thread it & screw it in.
Or press fit and weld .
Most likely both .
John
Press fit , weld , bolt and rivet John , take no chances
Will make a good video topic too
Cheers Mick.
(12-07-2014, 05:42 PM)doubleboost Wrote: [ -> ]...
It is a nice looking boring head
John
And big.
Ed
nothing rong with a big one
Well said Bob