MetalworkingFun Forum

Ken,

I plan on doing some rounding of the edges. Now that I know it all fits together properly I can work on making it prettier.

Ed

Ed - not a criticism but a question: is there any reason you didn't make it out of a single piece? I'm guessing it was what you had in "inventory" but curious if there is another reason.

Either way it is a beautiful bit of work.

Looking good Ed, glad to read that you plan to round those edges.

(02-09-2015, 05:10 AM)Mayhem Wrote: [ -> ]Ed - not a criticism but a question: is there any reason you didn't make it out of a single piece?  I'm guessing it was what you had in "inventory" but curious if there is another reason.

Either way it is a beautiful bit of work.

As you surmised, inventory dictated what I used.  
Well, also I'm following Henry's method and he used a two piece design.

Ed

(02-09-2015, 07:15 AM)stevec Wrote: [ -> ]Looking good Ed, glad to  read that you plan to round those edges.

Ya, those corner are sharp. I think I may taper the sides inward a bit also.

Ed

Ed, it would be good if you had a power feed to do those corners and tapers.

Steve

(02-09-2015, 10:33 AM)stevec Wrote: [ -> ]Ed, it would be good if you had a power feed to do those corners and tapers.

Steve

Kind of like needing a welding table to make a welding table.

Ed