04-10-2012, 10:20 AM
This is the dial holder that I made to fit the QCTP, makes holding the dial indicator on centre so much easier than grabbing a Magnetic base.
[attachment=750]
It was made from a scrap of material left over from making a set of bearing splitters, and a chunk of 1/2" keystock.
Here is is mounted in a QCTP holder, ready to drop onto the lathe, set for height and ready to go.
[attachment=751]
Walter
[attachment=750]
It was made from a scrap of material left over from making a set of bearing splitters, and a chunk of 1/2" keystock.
Here is is mounted in a QCTP holder, ready to drop onto the lathe, set for height and ready to go.
[attachment=751]
Walter