MetalworkingFun Forum
MetalworkingFun Forum
>
Machining
>
General Metalworking Discussion
> Material suggestions?
Full Version:
Material suggestions?
You're currently viewing a stripped down version of our content.
View the full version
with proper formatting.
Pages:
1
2
3
4
stevec
04-03-2015, 12:52 PM
Willie, it's a two way street (or highway) you've certainly cast your bread on the waters and it's good to hear that you've gotten back more than wet soggy bread. (boy! I'm waxing poetic today).
Steve
f350ca
04-03-2015, 12:54 PM
Great idea Dallen, stepped key material is even available,
Highpower
04-03-2015, 01:33 PM
No stepped key stock here Greg, but I do have a drawer full of the straight stuff - and a mill.
dallen
04-03-2015, 01:37 PM
I've seen stepped keys on gear drives that had a 150 and bigger HP motors hooked up to it.
Pages:
1
2
3
4
MetalworkingFun Forum
>
Machining
>
General Metalworking Discussion
> Material suggestions?