MetalworkingFun Forum

I am building a dividing head from a new 40:1 gearbox and i needed some fancy sector arms made. So i made this simple fixture to make a nice round end. I cut the flats on my shaper ( i have a vid someplace) and then rounded the ends with my sander. I just sanded flush to the bushing that was cut the right size with a bolt holding everything together. I will post some pics of the DH build...Bob

Bob,

They came out very nice

DaveH

Here is a little vid of my SBL shaper cutting the arms. That thing runs like a swiss watch...Bob
http://s110.photobucket.com/albums/n86/a...per004.mp4

(04-11-2012, 05:31 PM)aametalmaster Wrote: [ -> ]Here is a little vid of my SBL shaper cutting the arms. That thing runs like a swiss watch...Bob
http://s110.photobucket.com/albums/n86/a...per004.mp4

Shapers are so mesmerizing to watch.

Ed

HI a job well dun