MetalworkingFun Forum
MetalworkingFun Forum
>
Machining
>
Projects
> 5 Cylinder Radial
Full Version:
5 Cylinder Radial
You're currently viewing a stripped down version of our content.
View the full version
with proper formatting.
Pages:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
Brian
05-08-2021, 12:51 PM
Well its almost ready to go. only needs a non return valve in the oil tank and a drop of fuel.
so keep fingers crossed.
[
attachment=16997
]
Brian
Vinny
05-08-2021, 01:11 PM
Lookin forward to it!!!
Brian
08-09-2021, 03:57 PM
After a lot of fiddling with the mixture and going over valve and ignition timing. IT RUNS the mixture requires further attention and the oil system jet has to be smaller. but it has no vibration after all my fears about that.
Run time is 30 mins in two sessions.
[
attachment=17258
]
[
attachment=17259
]
[
attachment=17260
]
Yee Harr.
Brian.
TomG
08-09-2021, 06:09 PM
Congratulations, Brian!
Can't wait to see the video.
Tom
Vinny
08-09-2021, 09:26 PM
YAY!!!!
Hawkeye
08-09-2021, 10:21 PM
It's a thing of beauty, Brian. Great work!
Pete O
08-10-2021, 08:20 PM
(08-09-2021, 06:09 PM)
TomG Wrote:
[ -> ]
Congratulations, Brian!
Can't wait to see the video.
Tom
X2!
Dr Stan
08-10-2021, 08:38 PM
That looks like a wonderful project once I get set up in Manila.
Brian
08-10-2021, 11:03 PM
One video coming up
https://youtu.be/57J0WQEjbCc
6 years of work !!!
Brian.
Pete O
08-15-2021, 08:56 PM
A great result Brian. Just so you know, about 10 of the video views so far are me :)
Looking forward to the dyno results...
Pages:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
MetalworkingFun Forum
>
Machining
>
Projects
> 5 Cylinder Radial