I plan on putting 1 or 2 sets of rails underneath for shelves for tooling.
after reading about all the tables mine might be a little over built
it is about 3.5 x 3.5 x 3 tall , steel table 3/8 plate top 6 square tubing x 3/8 legs has 3/4 x 2 rails under top has 6 channel as stretchers my machine does weigh about 700 lbs.
(05-03-2015, 06:43 PM)wing98 Wrote: [ -> ]after reading about all the tables mine might be a little over built
Nope, seems good to me
DaveH
I just started drawing this out. Paper, not cad. Should the legs be straight or angled? If angled, what angle are we talking?
I've been texting with a guy that has a some 4" square and 2x4 square that appears to be a good price (I'll check supplier prices tomorrow).
That's good. Straight lines are easier to draw! :)
Stupid stupid stupid. Here I was planning on going out and buying steel for this table and when I looked out the back window of the shop a few mins ago what do I see? TWO, count 'em, TWO 19" open equipment racks. They're at least 3/16" U channel, 7 foot tall with a steel plate for a base that's at least 1/4" thick. They weigh about 75 lbs ea. Perfect for this table! I can hear the cutoff saw now! (and feel the money NOT leaving my pocket) I will still buy the stuff I found on Craigslist if he accepts my offer.
And on another note, he accepted my offer so I'll be getting a bunch of 4x4 and 2x4 and some other stuff that's at least 3/16 thick and I think some is 1/4" thick in 10' sections for $75. I pick it up Saturday afternoon.
(05-06-2015, 09:48 PM)Vinny Wrote: [ -> ]And on another note, he accepted my offer so I'll be getting a bunch of 4x4 and 2x4 and some other stuff that's at least 3/16 thick and I think some is 1/4" thick in 10' sections for $75. I pick it up Saturday afternoon.
Ed