MetalworkingFun Forum

Does anyone know of a source for a CCMT tool holder that can make use of the 100 degree corners for 32.XX sized inserts? I have one for the smaller 21.XX inserts but haven't found one for the larger inserts.

Ed

Have a look at the ToolMex web site.

(05-02-2015, 10:14 PM)Mayhem Wrote: [ -> ]Have a look at the ToolMex web site.

No luck there.

Ed

I've checked with Mitsubishi, NTK and Kyocera, nothing. I'm not saying someone doesn't have it, but if those three who specialize in small screw-down insert holders don't have it, you aren't going to have an easy time of it.

What's the maker and designation of the one you do have?

Thanks for checking Ken. The one I have is a Micro 100. They only make them for the smaller insert size though.

Ed

You've got a mill Ed...

I did check the Toolmex site and they do them for negative inserts only. I knew I had seen them there.

(05-03-2015, 10:43 AM)Mayhem Wrote: [ -> ]You've got a mill Ed...
...

Not yet.

Ed

1/2 a mill???

SECO has one, but I didn't bother to register just to find out how much they cost.   

https://www.store.secotools.com/webapp/w...Term=13316

(05-03-2015, 08:11 PM)Highpower Wrote: [ -> ]SECO has one, but I didn't bother to register just to find out how much they cost.   

https://www.store.secotools.com/webapp/w...Term=13316

$96