MetalworkingFun Forum

(05-21-2015, 05:40 PM)Mayhem Wrote: [ -> ]You have a mill - make a stop.

Sounds like a good idea know where I can get a plan for making one.

I like to make stuff on the mill.
I made a couple T-nuts and purchased a couple grade 8 bolts so I wouldn't have to rob the hold down set I bought for the mill.

Google will be your friend here.

The simple stop is one that bolts to the back of your vise (you should have two threaded holes already there). Something like this:

http://www.cnccookbook.com/MTMillKurtViseStop.htm

Look at the various adaptations and settle on one you like or modify one to suit your needs.

Here
http://www.metalworkingfun.com/showthrea...47#pid4147
another http://www.metalworkingfun.com/showthrea...11#pid3611

 
DaveH

(05-22-2015, 11:38 AM)DaveH Wrote: [ -> ]Here
http://www.metalworkingfun.com/showthrea...47#pid4147
another http://www.metalworkingfun.com/showthrea...11#pid3611

 
DaveH

Dave,

Find the thread on the one I made because I can't.

Ed

Hi Ed,
I looked mate - couldn't find it  
Are you sure you made one - I know you made a lathe stop but I don't remember a vice stop.
 
DaveH

Sorry Ed, you did make one and here it is finished
http://www.metalworkingfun.com/showthrea...0#pid21700

 
DaveH

Thanks Dave - I couldn't find them either.

(05-22-2015, 04:46 PM)DaveH Wrote: [ -> ]Sorry Ed, you did make one and here it is finished
http://www.metalworkingfun.com/showthrea...0#pid21700

 
DaveH

Thanks Dave you search god.

I guess I didn't do a full thread on that project like I thought I had.

Ed