MetalworkingFun Forum

Any suggestions on the best way to get all that grease off?

Kerosene and lots and lots of rag....

(06-17-2015, 06:32 PM)Thumb Wrote: [ -> ]Any suggestions on the best way to get all that grease off?

I think I used WD-40 to clean my stuff. That and lots of blue paper towels. 

Well, I have about 5 gallons of kerosine and lots of paper towels so maybe that will work. I'm moving my table
saw outside so maybe I can take some of that grease and put it on the table to keep it from rusting too. BTW, anyone interested in a 1960 Craftsman table saw that works?

I'm sure kerosene will also get the job done. The aroma in the shop will be different that with WD-40 but the end result will be the same. Good luck!!

WD40 is mostly kerosine, with some nice smelling light oil added.