08-03-2015, 02:58 PM
08-04-2015, 06:15 AM
Dave, 63.5mm plus two 5mm plates makes 73.5mm by my math.
Will it still fit? (your drawing shows a 2.5mm plate on each side but only 1 on the bottom.)
Steve
Will it still fit? (your drawing shows a 2.5mm plate on each side but only 1 on the bottom.)
Steve
08-04-2015, 12:18 PM
It will fit Steve,
Goes into a channel 75mm wide x 70mm deep. The two 20mm dia holes are for the two pins, one pin is used as a hinge and the other to lock it either in the working mode or in the folded mode.
DaveH
Goes into a channel 75mm wide x 70mm deep. The two 20mm dia holes are for the two pins, one pin is used as a hinge and the other to lock it either in the working mode or in the folded mode.
DaveH
08-07-2015, 07:04 AM
Got the castors (8 off) 125mm (5") wheel dia rated at 140kgs (300lbs) No plate - single bolt hole fixing.
[attachment=11557] [attachment=11558]
DaveH
[attachment=11557] [attachment=11558]
DaveH
08-07-2015, 11:04 AM
Nice castors Dave. Is the hole for mounting them threaded?
Ed
Ed
08-07-2015, 12:21 PM
(08-07-2015, 11:04 AM)EdK Wrote: [ -> ]Nice castors Dave. Is the hole for mounting them threaded?
Ed
Thanks, the hole isn't threaded just a plain hole 13mm dia for M12 or 1/2" bolt. Although an hex hd bolt doesn't normally fit too good, can't get the ring spanner or socket in so I tend to use a cap head/ button head.
It there is access one can use a nut, otherwise a 12mm plate with a tapped hole is welded on.
The reason I went for the single bolt hole is because the plate size on the castor is wider than the 63.5mm sq tubing, I could have welded a plate on the bottom of the tubing and then I'll keep catching my ankle on it
DaveH
08-12-2015, 12:47 PM
Cut the 63.5 sq tubing to size and tack welded the side plates on, checked to make sure it fitted.
[attachment=11577] [attachment=11578]
Welded the side plates a little more and drilled the two 19.5mm holes, cleaned it up a bit and checked to see if the pins would fit.
[attachment=11579] [attachment=11582]
Must be my lucky day.
DaveH
[attachment=11577] [attachment=11578]
Welded the side plates a little more and drilled the two 19.5mm holes, cleaned it up a bit and checked to see if the pins would fit.
[attachment=11579] [attachment=11582]
Must be my lucky day.
DaveH
08-12-2015, 12:51 PM
08-13-2015, 01:49 PM
I forgot to mention I didn't put a 5mm plate on the bottom, just one 5mm plate on each side.
DaveH
DaveH
08-16-2015, 11:59 AM