MetalworkingFun Forum

(10-01-2015, 03:51 PM)EdK Wrote: [ -> ]

(10-01-2015, 02:08 PM)DaveH Wrote: [ -> ]Moochers - that's a new word for me - never heard it before.
 
DaveH

Consider yourself lucky Dave. You don't want to associate with moochers.  

Ed

You're right there Ed, - I looked it up to see what they were. Get them here as well

DaveH

Ok, I need all you guys to look in your tool stealing black holes and see if you can find my oiler. I happen to find one at HF a few months ago with a flexible spout and the end fit and sealed perfectly with those ball bearing oil ports. I cleaned the chinese goo out of my rotary table today and after putting it back together the only thing left was/is to oil it. That can is nowhere to be found. So it musta slipped into that black hole. If any of you see it, kinda give it a tap to send it hopefully back in my direction. If I buy another one the odds aren't too good that it'll fit like this one did.

Damn you guys are good! A couple of minutes after posting that, it re-appeared right where it was supposed to be! Thanks!!!!

This work well with the ball oilers. Arvid clued me in on this one.

http://www.amazon.com/GOLDENROD-707-Indu...B00004YK76

Ed

(10-04-2015, 09:51 PM)Vinny Wrote: [ -> ]Damn you guys are good!  A couple of minutes after posting that, it re-appeared right where it was supposed to be!  Thanks!!!!

Glad to be of service Vinny. Anything for you brother...

(10-05-2015, 06:06 AM)EdK Wrote: [ -> ]This work well with the ball oilers.

http://www.amazon.com/GOLDENROD-707-Indu...B00004YK76

Ed

I've got the 24 ounce version. Enough power to shoot a stream of oil clear across the shop, so resistance from the ball oiler's is futile.  



McMaster has replacement spouts as well.

For the most part that's like mine except the flex line is that plastic/nylon/whatever hose with the braid in it. Haven't tried any distance shots with it yet.