MetalworkingFun Forum

[attachment=12180][attachment=12179][attachment=12178][attachment=12176][attachment=12176][attachment=12175]
Collet nut built for end mill holder.
Not pretty but worked very well.
Scrap socket used to tighten new nut.

hi I have one of them tool holders never had a go with it is it good for sharpening up the cutters

KRV3000.
Have not tried it yet as I think its to be used with a surface grinder.
It was picked up for a song because of missing parts.
May be possible  used with a Vertical or Horizontal Mill and Diamond wheel
Once I get the shop put back together I will try it.