MetalworkingFun Forum

Hi Bob,

Yikes, that's a bit pricey


DaveH

Bob,

Exactly what parts do you need? I'm sure we can help you source suitable parts for a whole lot less money.

Ed

Hi
Bob
I have a decent 240 volt motor under my bench
I am not far away from you (Newcastle) If you need a motor it is there
John

(04-18-2012, 04:27 PM)doubleboost Wrote: [ -> ]Hi
Bob
I have a decent 240 volt motor under my bench
I am not far away from you (Newcastle) If you need a motor it is there
John

Thats nice of you John


DaveH

hi thanks for the offer john i will se wat hapens ED i just contacted them for a comparison on ther prises i can get the swich for £10 the cap will be £6 and the motor a full rewind will only be £178 ther is motors out ther bran new for les but the foot print of wher the motor gose non of thes will fit in the thing im stuck on the most is the wiering its all a black art to me

Bob,

You should wait for John to come by and give you some help. It can be dangerous if you wire something incorrectly.

Ed

Hi Bob,

If John's spare motor doesn't fit, let me know - I have a couple of Chinese 2HP motors, pulls from VFD conversions - one's yours for a Scottle of Botch if they'd fit and we can work out how to get 'em to you!

Dave H. (the other one)
(deepest darkest Surrey)

HI all thank you all for your help but ITS A LIVE ITSA LIVE I got a new cap from RS £6 the chaps from emco sent me a diagram of the wiering I have just set it up on a on and off switch so it runs the right way i have orderd a new swich from RS well emco wont £60 for thers from RS with vat £12.78p so ones a gane thank you all for helping me and for the offer of replasment motors

Hey Bob, that's good news.

Ed