MetalworkingFun Forum

Full Version: Polycarbonate Vial Set
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Here is just one piece of many vials we make for our Biotechnology customer.

This vial and the caps are made in our Haas ST20 Cnc Lathe.  The material is FDA approved, Impact Resistant Polycarbonate.

The vial is made from clear tube, and the caps are made from solid bar stock.

[Image: 20160708_134954_zpshq4nbkhv.jpg]

[Image: 20160613_153229_zpsxrxtgltm.jpg]

[Image: 20160613_153114_zpsuzti1dcy.jpg]
Those look nice.
I know this is an old thread but those would be spectacular for holding drills, taps and such. Especially if you could customize the length. I always like to keep my taps in sterile condition. Are they prohibitively expensive?
Lots of square, telescoping boxes available. Do da Google.
Hi Robert, and Welcome to the forum.

Google " Tap Plastics ". They have just about every conceivable type of small container you might need.