MetalworkingFun Forum

Full Version: Flat Belt Drill Press
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Finally had a bit of time to edit this video, in from the heat and cleaning up the father in laws tool hoard.

Picked this up last week, I like drill presses, not sure what I'll do with this once I spruce it up.



i believe the square hole is for a belt tensioner. on a line shaft the shaft is always turning, tensioner will allow u to turn it off and on
I love vintage machinery like that. Are you going to set up an overhead belt drive for it? Big Grin

Tom
(08-09-2016, 08:17 AM)TomG Wrote: [ -> ]I love vintage machinery like that. Are you going to set up an overhead belt drive for it? Big Grin

Tom

I am seriously thinking about setting up something overhead to drive it. Just for the fun of it. Anyone know where I can get another belt cheap? Once I know what length I could get then I can build the overhead system. My ceilings are 10'-6" but I could put it against a wall and have a motor placed above at any height.
I bought the flat belt for my Logan on ebay. They make it to the length you specify. The ebay seller is validusgroup. A tractor dealer should also be able to make one to your specs.