MetalworkingFun Forum
MetalworkingFun Forum
>
Machining
>
General Metalworking Discussion
> How about this?
Full Version:
How about this?
You're currently viewing a stripped down version of our content.
View the full version
with proper formatting.
Vinny
01-14-2017, 05:28 PM
Got this off the machinist group on FB.
Welrod
01-14-2017, 05:31 PM
Inch
EdK
01-14-2017, 06:09 PM
I can't "PRONOUCE" it.
Ed
Vinny
01-14-2017, 10:29 PM
I must be getting slow, I never even caught that!
MetalworkingFun Forum
>
Machining
>
General Metalworking Discussion
> How about this?