MetalworkingFun Forum

MetalworkingFun Forum > Machining > General Metalworking Discussion > Hard turning on a knee mill.
Full Version: Hard turning on a knee mill.
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Viperspit

04-23-2017, 08:33 AM
Has any one out there tried hard turning in a mill? If so, what inserts do you like best and what technique do you use? Here is a YouTube video showing the inserts and technique I use. Hard Turning on a Acer Mill - YouTube

Steve

EdK

04-23-2017, 01:33 PM
Nice tip Steve.

Ed
MetalworkingFun Forum > Machining > General Metalworking Discussion > Hard turning on a knee mill.