04-26-2017, 09:40 PM
So, in my usual, clueless purchase mode, I have taken posession of a Boyar-Schultz OC knurling and burnishing tool, with a set of straight knurls. It seemed like a good idea at the time...
So I'm sure I can fumble my way through, but if anybody has some suggestions or instructions, it would sure be a good thing! Oddly enough, nothing at all on YouTube.
The first step will be figuring out how to hold it on the lathe. It has a 1" shank, but that's removeable, down to the 3/4" integral shank. IIRC, the South Bend has a 3MT in the tailstock, so I can get a collet that should work.
Any further instruction will be gratefully accepted!
So I'm sure I can fumble my way through, but if anybody has some suggestions or instructions, it would sure be a good thing! Oddly enough, nothing at all on YouTube.
The first step will be figuring out how to hold it on the lathe. It has a 1" shank, but that's removeable, down to the 3/4" integral shank. IIRC, the South Bend has a 3MT in the tailstock, so I can get a collet that should work.
Any further instruction will be gratefully accepted!