09-16-2017, 07:18 PM
09-16-2017, 08:54 PM
(09-16-2017, 07:18 PM)Dr Stan Wrote: [ -> ]Just learned of this software and have not used it.
http://lathegears.software.informer.com/
That's the same software we've been discussing on another thread. It isn't available via the link you posted.
Ed
09-16-2017, 10:04 PM
(09-16-2017, 08:54 PM)EdK Wrote: [ -> ](09-16-2017, 07:18 PM)Dr Stan Wrote: [ -> ]Just learned of this software and have not used it.
http://lathegears.software.informer.com/
That's the same software we've been discussing on another thread. It isn't available via the link you posted.
Ed
Hum. Guess I missed that thread.
09-17-2017, 08:21 AM
(09-16-2017, 10:04 PM)Dr Stan Wrote: [ -> ]Hum. Guess I missed that thread.
Here you go Stan.
http://www.metalworkingfun.com/showthrea...6#pid62476
Ed