MetalworkingFun Forum

MetalworkingFun Forum > Machining > General Metalworking Discussion > What the heck is (was) this?
Full Version: What the heck is (was) this?
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2

frankie

01-26-2023, 08:45 PM
Terry is correct it is a platen for rubber molding press. I worked as a machinist/mold maker for 42 years. I also notice that Terry is from Jordan MN. We may have worked at the same companies.
Frankie
Pages: 1 2
MetalworkingFun Forum > Machining > General Metalworking Discussion > What the heck is (was) this?