I am in desperate need of a "How to program my KCLY model KOC100-1R5S2-B VFD". I have the pdf file and have tried to follow the instructions in the manual but just can't seem to get started. I understand the first step is to input all the information necessary off of the motor plate. But what I need is a "First Push this button and then push this arrow etc etc." I have tried and tried and can not seem to get to first base. Any help would be greatly appreciated. I am trying to resurrect an old 5913 Clausing lathe that has a 2 hp 3 phase motor on it. I will be using the original hydraulic Reeves drive to vary the speed and the drum switch to change directions of rotation so all I need to do is make the VFD run the motor on 3 phase @ 60 hz. The VFD comes from the factory set up for 50 hz. Thanks again.
(05-14-2019, 06:50 PM)ltlvt Wrote: [ -> ]I have the pdf file
Please attach the PDF file to your next post so we can take a look at it and try to help.
Ed
Okay I am gona try again to attach the pdf file. I am new to how his forum works so please be patient with me.
Don't know what I am doing wrong. It does not load my attachments with the reply.
Instructions can be found here:
http://www.metalworkingfun.com/showthrea...5#pid14655
Don't forget to perform the last step of clicking the "Insert into post" button. That is what loads your attachment into your reply.
And don't worry about taking a bit of time to get acquainted with forum. We are a pretty patient bunch who have all been there - done that, just like everybody else.
One more time this is the pdf file for the VFD. I sure hope this works this time.
Click on your screen name / avatar, and then click on "User CP" toward the top left of the page. Then go to the "Miscellaneous" drop-down box on the left side of the page and click on "Manage Attachments". Let's make sure your .pdf file is actually in there before we get ahead of ourselves.