10-17-2019, 03:11 PM
Pages: 1 2
10-17-2019, 08:06 PM
Lots of facets... https://www.youtube.com/watch?v=hTj6LC6agrg
A mill with a digital readout that has an arc function will work too.
A mill with a digital readout that has an arc function will work too.
10-17-2019, 08:18 PM
Looks good. Have to give it a try.
Thanks for the tip.
Thanks for the tip.
10-17-2019, 08:57 PM
It could also be accomplished using a fixture with some stop pins assuming one could have a pin hole in the center of the circle. Just make sure you conventional mill, not climb mill.
10-18-2019, 08:36 AM
You are looking at this all wrong. You NEED a rotary table. Use this opportunity to buy yourself a new (or used) rotary table.
"Honey, I gotta have one. It's the only way to finish my project."
"Honey, I gotta have one. It's the only way to finish my project."
10-18-2019, 03:11 PM
(10-18-2019, 08:36 AM)rleete Wrote: [ -> ]You are looking at this all wrong. You NEED a rotary table. Use this opportunity to buy yourself a new (or used) rotary table.
"Honey, I gotta have one. It's the only way to finish my project."
You're really making it hard to not get a rotary table.
10-18-2019, 07:31 PM
(10-18-2019, 03:11 PM)Paulc Wrote: [ -> ](10-18-2019, 08:36 AM)rleete Wrote: [ -> ]You are looking at this all wrong. You NEED a rotary table. Use this opportunity to buy yourself a new (or used) rotary table.
"Honey, I gotta have one. It's the only way to finish my project."
You're really making it hard to not get a rotary table.
But rleete is correct. How do you think I ended up with a 24 X 48 X 12ft shop packed full of tools?
And yes I have a rotary table and an indexer.
10-19-2019, 10:48 AM
(10-18-2019, 03:11 PM)Paulc Wrote: [ -> ](10-18-2019, 08:36 AM)rleete Wrote: [ -> ]You are looking at this all wrong. You NEED a rotary table. Use this opportunity to buy yourself a new (or used) rotary table.
"Honey, I gotta have one. It's the only way to finish my project."
You're really making it hard to not get a rotary table.
Keep in mind that a rotary table has more uses than just cutting circles and arcs. They are also useful for indexing/dividing as well.
10-19-2019, 03:25 PM
Just added a HT furnace to my "need" list.
10-19-2019, 03:39 PM
You guys are quite persuasive .
Finally broke down and ordered a rotary table.
Now just have to figure out how to use it!
Finally broke down and ordered a rotary table.
Now just have to figure out how to use it!
Pages: 1 2