Not much but I added a chuck key holder for the 4-jaw chuck. It's been so dead around here I thought I'd go ahead and post it.
Ed
[
attachment=17180]
Again, nothing fancy. Just a holder for the lathe dogs. I forgot to add spots to accommodate the drive pins so I had to make it separate.
Ed
[
attachment=17193]
Nothing new, just another collet holder since I bought three more collets. The 4th one is on back order.
Since it's dead around here I thought I'd post it anyway.
Ed
[
attachment=17284]
Tool holder for my drill press. The two chuck keys are a bit too close together but they work. I'll add 1/8" to the distance between them to the drawing just in case I reprint this at a later date. The two open spots are for two more strap clamps.
Ed
[
attachment=17300] [
attachment=17301]
[
attachment=17302]
Printed this hygrometer holder that snaps into the center of the filament spool. I can monitor the humidity while in the bag.
Got the STL file off of Thingaverse.
Ed
[
attachment=17304] [
attachment=17305]
Printed up some blocks for hanging my QCTP tool holders. I've got 11 holders, 5 unused. I can add two more blocks to the wall, I just need to print them.
Ed
[
attachment=17306] [
attachment=17307]
Made a box for my thread gauges. I stored them for many years in the plastic pouches they came in but they don't stack very well so I printed up a box with a sliding lid to hold them.
Ed
[
attachment=17401] [
attachment=17402]
[
attachment=17403]
I see that you are using different colors for your containers. I am assuming that is so you know what is inside without having to open them. I know I'd lose track of what I had stored in them about 10 minutes after I put the container in the drawer.