MetalworkingFun Forum

Full Version: RF-45 Downfeed Lock Knob
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2 3 4
I felt like doing a small project last night so I decided to make a better knob for my RF-45 Style Mill down-feed lock. This knob when tightened allows the fine feed to operate and when loose allows the drill press style handle to operate. The original knob is made of cheap plastic. Here's a photo:
[attachment=1755]

I didn't think to take pictures during the lathe work. I turned the knob from a 1.6" long 3" round piece of 6061 aluminum. After I finished turning and boring the blank, I milled the cutouts around the rim.
[attachment=1756]
Here's a closeup. I made each cutout with a boring bar set to cut a 7/8" radius. The rotary table is turned 60 degrees for each cutout
[attachment=1757]
Here's the finished knob. I used my new Shop Press to press fit a 10mm x 45 mm cap head screw.
[attachment=1758]
My new knob has a nicer feel and also looks better.
[attachment=1760]
Henry,

Nice job on the new knob. You've just added another project to my list. That looks like a fun project though. Smile

Ed
Henry,

That looks a lot betterThumbsupThumbsup
John
Henry,

Very nice, in fact I think that is rather splendid Smiley-signs107 Worthy
Smiley-eatdrink004
DaveH
(06-02-2012, 02:18 PM)DaveH Wrote: [ -> ]Henry,

Very nice, in fact I think that is rather splendid Smiley-signs107 Worthy
Smiley-eatdrink004
DaveH
well dun
Henry,

Love your knob!!!Drool

RotflRotflRotflRotflRotflRotflRotfl

Nicely done!!Smiley-signs107Big Grin


Jerry.Popcorn
Nice, I never thought of using the boring head to make the grips
(06-02-2012, 08:23 PM)f350ca Wrote: [ -> ]Nice, I never thought of using the boring head to make the grips

I thought that was rather clever of Henry. I learned something new from his post. Thumbsup

Ed
(06-02-2012, 12:16 PM)henryarnold Wrote: [ -> ]Here's a closeup. I made each cutout with a boring bar set to cut a 7/8" radius.

Henry,

7/8" radius? On a 3" diameter knob? 17428

Maybe just my eyes playing tricks on me, but they don't look to be that big to me.

Smiley-signs137
(06-02-2012, 09:26 PM)Highpower Wrote: [ -> ]Henry,

7/8" radius? On a 3" diameter knob? 17428

Maybe just my eyes playing tricks on me, but they don't look to be that big to me.

Smiley-signs137
A 3" diameter knob has a circumference of almost 10" and those 7/8"
radius sectors (not full diameter) are probably around 3/4" across so I'd say, Ya your eyes must be playing tricks on you.
(or mine areChin)
Or maybe Henry meant 7/8" Diameter?
Oh, never mindBlush
Pages: 1 2 3 4