I've found plenty of spindle nose dimensions for the face, but none of the side view. Can anyone help me out?
(03-15-2024, 09:29 PM)Dr Stan Wrote: [ -> ]I've found plenty of spindle nose dimensions for the face, but none of the side view. Can anyone help me out?
Is this what you're looking for?
D1 Spindle Specs
Ed
(03-16-2024, 02:51 AM)EdK Wrote: [ -> ] (03-15-2024, 09:29 PM)Dr Stan Wrote: [ -> ]I've found plenty of spindle nose dimensions for the face, but none of the side view. Can anyone help me out?
Is this what you're looking for?
D1 Spindle Specs
Ed
I've seen that one before. It has the specs for the end of the spindle nose, but not the ones for the locking pin holes that are at 90 degrees to the center line. Those are the ones I need. These are for the pins one turns to about 90 degrees when locking the work holding device to the spindle nose. I can fairly well guess at them but, I'm adverse to doing so as I'll be using a nice piece of 4340, 6" dia and 2.5" long.Not the easiest thing to locate here in the PI.
Yeah! and thank you. Been in the hospital which is why I haven't responded. Glad to be back home and starting to get busy again, slowly.
(03-25-2024, 11:53 AM)Highpower Wrote: [ -> ] (03-24-2024, 10:48 PM)Dr Stan Wrote: [ -> ]Glad to be back home and starting to get busy again, slowly.
Spent four days in a poor excuse of a hospital, but then at least I exited in better shape than I entered. Taking a high powered antibiotic (Cipro) that is the go to med for anthrax. It should knock out whatever is attacking me.