MetalworkingFun Forum

Full Version: change wheel locks
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
hi i had to mack thees up they for making changing the gears easy i made two washers for the square witch is 13mm and two for the shaft Clarence witch is 10mm with a 1mm step on the back i cut threw the edge of the 13mm one then filed square did the same to the 10mm one but left it round then silver soldered the two together right pics
Nicely made Bob ThumbsupThumbsupThumbsup
Smiley-eatdrink004
DaveH
Good job Bob. You never cease to amaze me.

Ron
thanks ron and dave