(06-20-2012, 12:58 PM)November X-ray Wrote: [ -> ]The handles in the pictures are aluminum, not sure what the ones are made of from Enco, but how would you fasten them to transfer the torque,,,,roll pins perhaps?
I'm a firm believer in Loc-tite 609 sleeve retainer. If it's good enough to hold bearing races in jet engines, it will hold a couple of sockets just fine.
Incredible strength to it.
(06-20-2012, 11:18 AM)Highpower Wrote: [ -> ]I don't suppose anyone knows if such a thing exists? And no....... I can't afford to purchase a $$$ hex broach to make one. 
You could always practice your filing skills. Wouldn't take long in aluminium.
regards
bollie7
(06-20-2012, 01:12 PM)stevec Wrote: [ -> ]...Unless one applied a cheater bar long enough, but then you'd be in danger of tipping over the mill
...
That would be one hell of a cheater bar!