Very impressive ! I wish I had your machining skills! I just finished an 80% AR Lower in cast aluminum and I thought I did a good job. In my defense, this was my first project on my new cheapo Grizzly mini mill. Never have used a mill or lathe before. You however, look like you may have been at this awhile!!! I love the learning curve.
(06-20-2012, 04:48 PM)doubleboost Wrote: [ -> ]If we start playing with guns we will get locked up.
John
Same here in Canukistan, John.
Steve
(11-30-2013, 09:49 PM)d65 Wrote: [ -> ]Very impressive ! I wish I had your machining skills! I just finished an 80% AR Lower in cast aluminum and I thought I did a good job. In my defense, this was my first project on my new cheapo Grizzly mini mill. Never have used a mill or lathe before. You however, look like you may have been at this awhile!!! I love the learning curve.
I would love to see some pictures of your finished receiver.
Mine was a first effort on my cheapo Enco mill, so you aren't alone.
