Almost there. Only milling to go.
"Billy G"
That's a very nice pair Bill.
Thank you, just over 23 hours work Tom. I'm beat.
"Billy G"
Nice work. I really like radials, will be watching with interest.
Bill, this is getting exciting.
Asbalest thank you very much, Hawkeye, nice to see you. OK people, if you are not into repetative operations this is a bad project for you. Slave rods are next. Again these will be for the 18, not the 14 cylinder. That translates to 16 of the same part. See you soon.
"Billy G"
Still needs to be bolted to the table but this is the set-up for cutting the 16 tooh gear which is an integral part of the crankshaft forward part.
"Billy G"
Picture posting problem at this end. It is more complicated that windows 7.
"Billy G"