MetalworkingFun Forum

Full Version: P&W 1830 Radial in 1/6 scale.
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30
Minor misunderstandings. Unfortunately, it's the nature of the beast, the internet that is. Let's just concentrate on the wonderful build thread Bill has started. We're all here to learn and enjoy exchanging information about metalworking.

Ed
Looking good so far Bill. Do you have a pic of what the end result will be, so we can see what you are building towards?

Bill Gruby

Hopefully it will be close to this Darren.

"Billy G"
Bill,

Wow, this is going to be one great build, really looking forward to it Bill.

Smiley-eatdrink004
Dave
I agree Dave! I'll be following this with interest Bill.
Bill,

That's one serious project you're embarking on. Good luck and we'll all be watching this thread, I'm sure.

Ed

Bill Gruby

Thanx everyone. Sometimes a little encourgement helps to continue.

Next up was the Super Charger housing. Lots of boring here. It fits just ahead and is attached to the Gearbox.

"Billy G" Big Grin
Bill
That is a fine looking engineDroolDrool
You are making a great start
Keep the pictures comingBig GrinBig GrinBig GrinBig Grin
John

Bill Gruby

Thanx.

Before moving ahead I wanted to do the oil pump. This was a nasty little bugger to do.The pix shows the print and blanks. Also some special tooling had to be made. It is an adustable center arbor for the faceplate.

"Billy G" Big Grin

Bill Gruby

Gear blanks had to be made.

"Billy G" Big Grin
Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30