I have many hours into this engine at this point. If you wish I can start from the beginning or here?
"Billy G"
Bill,
From the beginning please Bill
DaveH
OK square one it is. I started with the rear gear housing. 5.250 dia 4.750 long 7075. Remember again this is being done on a 9 inch import. One key note, there is no casting for this part, it and most of the others are barstock. Only the heads and pistons will be from castings.
"Billy G"
(06-30-2012, 07:53 AM)Bill Gruby Wrote: [ -> ]Remember again this is being done on a 9 inch import.
"Billy G"
Bill, Isn't it a "modified" and "Tuned" 9 inch import
DaveH
Pulled my chair up and got my soda, ready for the long haul.
Ron
(06-30-2012, 08:20 AM)ozzie46 Wrote: [ -> ]Pulled my chair up and got my soda, ready for the long haul.
Ron
You may have to change chairs before this is over.
"Billy G"
On the face plate boring the dtarter hole. Starter meaning electric starter. It will also sport a variable pitch prop when running. Don't let this pic fool you, there are two more bolts holding that mass from the other side.
"Billy G"
OOOOKKKK!! I'm on board Bill,
the train can now leave the station.
O and I brought popcorn
This will be good
Jerry.
Back into the three jaw to bore the main hole.
"Billy G"