MetalworkingFun Forum

I need to replace the bearings in the motor for my mill. The pulley was well and truly stuck onto the shaft and the motor diameter exceeded the limits of my press. So into the scrap bin, a couple of welds, the pressure screw (borrowed) from another puller and a few nuts, bolts and washers:

[attachment=2296]
[attachment=2297]
[attachment=2298]

Propper job
John

Mayhem,

Well done

DaveH

Thanks guys - one of the easier jobs I have done lately. I may have to get a bigger box to put my 'special' pullers in. One I have is about 1m long.

Improvise, adapt, and overcome. Outstanding!

Willie

Well done,

Jerry.

Thanks guys.

For those of you who are still scared of your welder, the same result could have been achieved using angle iron for all the components.