MetalworkingFun Forum

Hi
Lads
Made a start machining the engine base cast yesterday
http://www.metalworkingfun.com/showthread.php?tid=581
I cant do much untill i get the cylinder cast & machined
This bit was just plain hard work ,eventually i had a nice flat face to work from


It is a decent size when you see it on the mill





John

well thers no holding you back craking job did you use the tufnol for the paking of the mold boxes

Hi
Bob
We used it to ram the flasks up on (nice and flat)
We did not want to get ant molten metal on it as it burns well and gives off nasty gas
John

John,
That's a little mill you have, I always thought it was bigger than that

Only just fits, looking good

DaveH

no problem john

Looking good John

Hi
Lads
Not much progress to report
I was hoping to get the cylinder cast today
I painted the modified patern yesterday and the paint reacted (it looked like it had the pox)
Paint stripper and start again is the only way





John

John,

I see you have the shiny paint camera.

Ed

(07-29-2012, 04:58 PM)EdK Wrote: [ -> ]John,

I see you have the shiny paint camera.

Ed

It is just on loan
John

(07-29-2012, 04:58 PM)EdK Wrote: [ -> ]John,

I see you have the shiny paint camera.

Ed

Ten out of ten

John,
It is a big 'un

DaveH