Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.
ClaudeF
(08-16-2012, 07:09 AM)claudef Wrote: [ -> ]Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.
ClaudeF
It sure looks like it works well. Tight and tidy clamps.
ClaudeF,
Nicely made tool
Looks like it's works very well too
DaveH