Those Singer machines were built to last
when you say your Gran then your mom owned one that will go on for generations to come before anything wears out
If only things were built like that today . . . . . . A crime to toss it onto the tip ......... good job you were there to rescue it.
I have a foot operated K29 leather stitching Singer that is almost 100 years old and still going the same as the day it was made
Cheers Mick
(05-08-2013, 08:34 PM)f350ca Wrote: [ -> ]Not so much what I did but what I found. As near as I can date 1954 made in Canada. Was sitting at the dump today. Brought it home and it runs and sews like a charm, the light even works. Need to re glue the base.
My grandmother had one similar to that but it was probably older. I wonder what happened to it (thinking out loud).
Ed
well my dad fetched one of them home for me mam a bit off topic but me dad was in the spechel forces during ww2 and ges what they had to hall up and dawn bennevice in training
Simple job today. The trigger on the hose gun broke "Just plastic rubbish"
So a couple of hrs pottering in the shop put me in the wife's good books, she can now water her flowers.
[
attachment=5222]
[
attachment=5223]
Brian
Plastic has its place, but that's definitely not one of them. Nice job Brian, it never hurts to add a few extra Brownie points.
Tom
Whoa! Ang on, ang on.
What material did you use Brian?
I mean, is it aluminum and you were able to send to Tom for internet anodizing?
Or maybe some kinda Sicilian silver?
No, I'll bet you have a 3-D printer?
I worked on the work stop for my vise. The rod that is bolted on to the back of the vise is just hardware store zinc plated 1/2" mystery steel. The two blocks are made from some 7/8" 12L14 that I had laying around. Next is to make the brass clamps and then chamfer the edges of the blocks to make them look pretty. I think I'm going to paint the blocks to match the vise.
Ed
[
attachment=5239]
[
attachment=5240] [
attachment=5241]
took all the screws out of this and watched it fall apart in my hands
[
attachment=5242]
(05-10-2013, 03:31 PM)stevec Wrote: [ -> ]Whoa! Ang on, ang on.
What material did you use Brian?
I mean, is it aluminum and you were able to send to Tom for internet anodizing?
Or maybe some kinda Sicilian silver?
No, I'll bet you have a 3-D printer?
It's Hi grade scrap steel from a old balcony, Steve. Painted with with a auto selected finish ( the first spray can on the shelf )
Real Hi Tech not for the faint hearted to attempt.
Brian.